You should sand cabinets before beginning your how to paint kitchen cabinet project to give the new paint a good surface to grip. But you don’t need to sand to bare wood. If your cabinets have a factory finish, sand lightly with 120-grit sandpaper or a sanding sponge. If the surface is rough from a previous paint job or poor varnishing job, start with coarser 100-grit paper to remove bumps. Then sand again with 120-grit to get rid of any sanding marks.
"When selecting materials, be aware of the cumulative effect of patterns. Veining and designs in tiles and flooring, decorative details on hardware and cabinetry can "crowd" a room. On the other hand, using only small-scale patterns can emphasize that the room is small. Incorporating larger scaled moldings or architectural features sparingly can give the room more importance." - Faulkner House Interior Redesign, LLC
Depending on the scale of your project, you might not need a full-on architectural commission, which involves extensive meetings, multiple job-site visits, and several sets of construction drawings, to the tune of about 8 percent of a project's construction budget. You might be able to tap an architect's design savvy by having him undertake a one-time design consultation. For example, for a $400 flat fee, Baton Rouge architect Kevin Harris will meet with a homeowner, examine the problem, and sketch out a few solutions that could be as simple as opening up a partition wall or moving a door. The homeowner can then give the sketch to a builder or take it to a drafting service, which will charge about $1 to $1.50 a square foot to crank out formal construction drawings.
A full grand surround turns a conventional shower into a steam shower. A transom installed above the door could be utilized in a way where it would dry the shower every time you close the door. Likewise, placing the fan near the transom can also help in drawing air out of the shower every time you close the door. For those with a steam shower, it’s highly recommended to incorporate a bigger bathroom fan. Don’t forget to check the grout lines as well. Fewer grout joints are recommended because there’s less surface area to absorb moisture.
Such welcoming and soothing colors. This palette beckons to those that are seeking a calm and serene oasis. These are very similar to the neutrals found in nature but in a more muted and calming effect. Instead of all shades of nature this focuses only on the subtle and soft palettes of mother nature. With the soft colors of the sand, forest and sky. A reminder of the beauty all around us.
Not only is a "matchy-matchy" look boring, but buying entire suites of furniture tends to cost more than putting together a creative, eclectic look. Mix it up by opting for a couch and chairs upholstered in complementary fabrics, flanking a bed with unmatched nightstands and decorating with other diverse items unified by color, form, material and tone. Or try pairing a stately wood table with shiny aluminum or brightly colored plastic chairs. And don’t be afraid to mix high-end and low-end or modern and traditional.
I will say that we had a lot of trouble with Ikea. They messed our order up and I ended up having to go back two additional times, which was a hassle (we live on an island, Ikea is a $150 ferry ride away). In the end, I’d do it the same way next time. The price difference was just too much to ignore. Though I’ll be more careful to check over what they’re giving me next time!
When you're ready to call it a day, you can soak your roller in paint and then wrap it in a plastic bag so it's airtight. If you're returning to the job the next day, that'll work fine. If it's going to be a while, you can still put the bag over the roller, but then use it to pull the roller off without covering yourself in paint. Then use a new roller the next time (see: Don't be cheap). As for your expensive brush, you can wash that out—presuming you're using latex paint, which is water-based. Drag a hose to an out-of-the way spot and wash the brush while alternately rapping it against the bottom of your shoe to shake out the bristles. Do that until it's clean and it'll be ready to go the next time you steel your courage to tackle another room.
We were fortunate enough to have a couple of friends advise us on certain parts of the project. This made things much easier and saved us a couple of costly mistakes. For example a carpenter friend advised me to get some fans and dry the subfloor out rather than cut it out and replace it. Worked just fine and saved me a thousand bucks in plywood and a couple of days work.
We have not upgraded our kitchen light fixture. It’s on the list but we just couldn’t fit it into the budget. It’s a simple things to upgrade down the road when we have a few extra bucks and this way we can keep an eye open for a sale. The same goes for our appliances. As much as we love our almond stove (not at all), we really wanted a nice new set of stainless appliances.
You don’t have to buy new pieces to turn your tired domicile into a hip space. Instead, turn a fresh eye to what you already have and think about how it might be camouflaged, repurposed or reimagined. Reinvent a drab dresser in a guest bedroom as a dramatic dining-room sideboard with a few coats of glossy black paint and sparkling new hardware. Make over that old couch with a slipcover in a fabulous fabric. Turn plain pillows into eye-catching accents by stenciling simple designs on them. After all, there’s no better budget stretcher than your imagination.
Pro Tip: Use an enamel underbody primer. Water-based paint has come a long way, and some top-quality acrylic alkyd hybrids rival oil-based paint. Still, many pro painters prefer oil-based paint, especially for priming. Oil-based paint dries slowly and levels well. This gives you more working time and fewer brush marks. Also, when they’re dry, oil-based primers like Benjamin Moore Fresh Start Enamel Underbody sand easily to provide a perfect base for your finish coat.
Instead of using white primer, pros usually have it tinted gray or a color that's similar to the finish paint. Tinted primer does a better job of covering the existing paint color than plain primer, so your finish coat will be more vibrant and may require fewer coats. This is especially true with colors like red or orange, which could require three or more coats without a primer.
×